Some would be so fine they won't work, but some are quite coarse. Tea balls can usually be found in a few different mesh sizes. A coarser mesh would work for frozen things, like bloodworms, and prevent them all sinking in one spot, I think. I'm going to get a couple more tea balls and make a worm feeder for each tank. One or two worms sank past him and all of them will eventually get out, that are not eaten, but it appears to work perfectly. The fish figured out what was up in less than 5 seconds, and was happily pulling worms off the bottom of it by them. The worms were slowly wriggling their way out in seconds. I just cut the hinge off and the clamp/chain bit.įloated my first one in a Betta tank to see how it went. A small piece of this foam, with a suitable size hole in the middle, was all I needed to float one of the halves of the tea ball. It's a white foam sheet with so much air in the foam it weighs nearly nothing. It's not classic bubble wrap, but it's similar. It was just the right size for a cutting guide, to cut a hole in some plastic packing stuff. I took the ring from a gallon water jug, the one left on the neck, after you twist the cap loose. Two hemispheres of SS mesh, fastened with a loose hinge on one side and a wee clamp on the other side, and a chain to lift it out of the tea pot. Commercial worm feeders have plastic mesh which is much too coarse, Black worms just fall straight through them in a few clumps. They often grab several and the rest will sink while one gets slurped up. Given I buy California Black worms every couple of weeks for all my fish, I've been looking for some way to feed them without just dropping them in, and without having to stand and hold a chopstick while the Betta's rip them off the stick.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |